Siemens Sinumerik 810T User Manual

Page 206

3 Operating Sequences

01.93

3.2.3 Influencing ”AUTOMATIC” operation

This screen form appears with the
input field marked in inverse video.

((Foto - Nr. 810T/47 einmontieren))

After ”BLOCK SEARCH”, you can traverse the difference between the actual position and
the calculated command position, by selecting the axis and using the jog keys, in ”REPOS”
operating mode.

Block search in the L95/96 cycles: if comment texts are in the contour

program without block numbers, the control outputs the alarm 3000

“General programming error”.

Using the numerical keyboard enter the pro-
gram number ” ... ”, and store it with the input
key.

Using the numerical keyboard enter the block
number ” ... ” for the search destination, and
store it with the input key.

Operate the ”START” softkey.

Using the ”Program start” key, activate
program processing.

• • •

...

• • •

...

START

Input “%” for the main program or “L” for the
subroutine and then press the input key. The
inverse marking jumps to the next field for the
program number.

The axis positions programmed in the current block are

approached with linear interpolation.

Caution: danger of collision!!

3-102

SINUMERIK 810T, GA3 (BN)