4 automatic tool offset – Siemens Sinumerik 810T User Manual

Page 110

01.93

3 Operating Sequences

3.1.4 Tool offset

3.1.4.4

Automatic tool offset

This function requires a tool gauging device.
The coordinates of the measuring point of the workpiece (referring to the machine) should be
entered as ”Reference plane” point. This is achieved by coordinating the point of the turning
tool with the measuring point and reading off the X and Z values on the gauging device. The
tool must be selected from type 1 ... type 9.

Using a softkey, select either of the ”JOG” or ”INC 1... 10 000”
operating modes.
Now coordinate the tip of the turning tool with the measuring
point of the tool gauging device.

Now operate the ”AUTOMATIC TOOL OFFSET” softkey.

Extend the softkey menu displayed, using the ETC key to the
right below the display.

JOG

INC...

AUTOM.
TOOL

Sequence of operation

This input screen form appears with
the input field marked in inverse video.

((Bild 810T/17 einmontieren))

3-11

SINUMERIK 810T, GA3 (BN)