Siemens Sinumerik 810T - Manual (Page 138)

09.91 3 Operating Sequences
3.1.9 TRANSMIT coordinate transformation
3.1.9 TRANSMIT coordinate transformation
The “TRANSMIT” function is an ordering data option.
Definition: TRANSMIT = TRANSformation Milling Into Turning,
The TRANSMIT coordinate transformation permits face milling of turning parts on a turning
machine. You program the milling operation in a fictitious (Cartesian) coordinate system.
Machine movements are executed in the real machine coordinate system. The machine
manufacturer defines the axes for the fictitious coordinate system via machine data.
The TRANSMIT function can only be run in channel 1.
3.1.9.1 Behaviour of the transformation in the modes
The transformation either be deselected on a RESET or still be active after a RESET. This
facilitates operation of a grinding machine, for example, where the transformation generally
remains active permanently.
The machine tool manufacturer defines whether the
transformation is deselected on RESET or whether the
transformation state remains. For further details,
consult the machine manufacturer's instructions.
Exception: The TRANSMIT function is always deselected by the change to the “REFPOINT”
mode (reference point approach).
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-37
SINUMERIK 810T, GA3 (BN)