Siemens Sinumerik 810T User Manual

Page 37

09.91

2 Operation

2.1.1 SINUMERIK 810T operator interface

with integrated machine control panel

Key for the selection of operating modes

You use this key when you want to select operating modes or further
softkey functions.
The menu selected is shown on the bottom two lines of the CRT display
(menu for softkey functions see Section 2.1.1.1).

Operate the

key

until you see the menu for the following operating modes displayed:

Operate the

key a second time

A menu of further softkey functions is displayed.
The menu displayed depends on the current operating mode, which is
shown on the first line of the display (see Section 2.1.1.1).
For detailed information see Sections 2.3.3 to 2.3.6 and 2.4 !

You can extend the displayed operating mode menu:

Operate the ETC key

below the CRT

The extension of the operating mode menu is shown :

Section of the CRT display with menu of the operating modes

REPOS

AUTO-

MATIC

JOG

MDI-

AUTOM.

PRESET

Section of the CRT display:
1st extension of the operating mode menu

INC

1 000

INC

10 000

INC

100

INC

2-21

SINUMERIK 810T, GA3 (BN)