Siemens Sinumerik 810T - Manual (Page 159)

11.90 3 Operating Sequences
3.1.12 Program correction (”EDIT”): Insert/modify/delete word, insert/delete block
3.1.12.1 Correction display (”CORRECTION BLOCK”)
When processing or simulating (see Section 3.1.14) a program, the program processing is
stopped and the relevant alarm displayed when the control recognizes a programming error.
Using the ”CORRECTION BLOCK” function the block or the word to be corrected will be
marked.
Operate the ”PART PROGRAM” softkey, and then
subsequently the ”CORRECTION BLOCK” softkey, in any of
the operating modes:
PRESET / JOG / AUTOMATIC /
INC 1 .... INC 10 000 / REFPOINT.
Using the keyboard, now correct the relevant address
(address ”X” in the example) and enter the appropriate
value,
subsequently operate the ”Modify word” key.
The cursor is now positioned in front of the block/word recognized as containing an error.
CORR.
BLOCK PART
PROGRAM
• • •
X
7 ...
Sequence of operation
After the correction operate the “Program start” key to
continue program progressing.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-57
SINUMERIK 810T, GA3 (BN)