Siemens Sinumerik 810T User Manual

Page 21

Text mode
Original mode

01.93

2 Operation

2.1.1 SINUMERIK 810T operator interface with integrated machine control panel

NC-MD

Press the ”NC-MD” softkey.

272*

Call up MD 272* with this key. Position the cursor on the
desired axis
*=0

1st axis

*=1

2nd axis

*=2

3rd axis

*=3

4th axis

*=4

5th axis

*=5

6th axis

*=6

7th axis.

Press the ”Modify word” key.

The new compensation value is shown in the MD:

“Feed hold” display

The red LED is bright when the feed is interrupted.
The program run is stopped.

“Program running” display

•

The green LED is bright when a program is being processed, even if
the machine is not moving any axes!

•

The LED is extinguished when program processing is completed:
– on programmed Hold M00, M01
– at the end of a single block
– at the end of the program.

2-5

SINUMERIK 810T, GA3 (BN)