2 influencing simulation – Siemens Sinumerik 810T User Manual
Page 177
3 Operating Sequences
09.91
3.1.14 “SIMULATION”
Operate the ”SIMULATION” and ”START”
softkeys, one after the other.
The control now simulates the motions programmed on the CRT.
You can interrupt simulation at any time simply by
pressing the “STOP” softkey.
If you press “RESET” softkey, simulation is aborted.
SIMULA-
TION
START
STOP
RESET
3
.1.14.2 Influencing simulation
The simulation can be influenced so that it is adapted to the program sequence in
”AUTOMATIC mode”.
Operate the ”PART PROGRAM” and ”EDIT” softkey,
one after the other in any of the operating modes:
PRESET / JOG / AUTOMATIC /
INC FEED 1 .... INC FEED 10 000 / REFPOINT.
PART
PROGRAM
EDIT
Sequence of operation
3-74
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)