Siemens Sinumerik 810T - Manual (Page 225)

11.90 3 Operating Sequences
3.2.6 “PLAYBACK”
This display shows an example of a
block ”N1”, entered using
”PLAYBACK”.
(( 810T))
(( Bild 54 von Druckerei
einmontieren
• • •
Operate the ”Program start” key after
each block is entered.
This transfers the block to the program
memory.
Blocks not required can be deleted by
entering the block no. ” N...”, and
operating the delete key. Blocks traversed
correctly remain - as entered - in the
memory.
After each ”RESET” using this key, the pro-
cessing of the program can be repeated.
Continuing TEACH IN / PLAYBACK after RESET
Set the mode selector switch to the symbol
for ”AUTOMATIC”.
Enter the desired part program number
”%...” in the ”AUTOMATIC”basic display
and store it with the input key.
Then operate the ”PART PROGRAM”
softkey followed by the ”TEACH IN /
PLAYBACK” softkey.
N
...
PART
PROGRAM TEACH IN
PL.BACK
and
%
... ...
• • •
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-119
SINUMERIK 810T, GA3 (BN)