Siemens Sinumerik 810T - Manual (Page 223)

11.90 3 Operating Sequences
3.2.5 ”TEACH IN”
You can delete the blocks not required by
entering the block no. ”N ...”, and operating the
delete key.
Blocks traversed correctly remain - as entered -
in the memory. They do not have to be
acknowledged.
The blocks entered can be traversed using the
”Program start” key.
N
...
3.2.6 ”PLAYBACK”
Using the ”PLAYBACK” function in the ”AUTOMATIC” operating mode, you can program
linear movements.
The position values are approached at JOG traverse rate. Positions traversed to are transfer-
red into the program memory.
The blocks entered are transferred into the program selected in the ”AUTOMATIC” basic
display.
”TEACH IN” and ”PLAYBACK” can be used alternately for generating a part program.
When changing from ”AUTOMATIC” mode to ”JOG” or ”INC ...” mode the ”TEACH IN”
and ”PLAYBACK” functions are retained.
After switching back from ”JOG” or ”INC ...” to ”AUTOMATIC” , ”TEACH IN / PLAYBACK”
must be reselected.
Sequence of operation
At least one complete part program block must be entered and
traversed.
1, 10, 100,
1 000, 10 000
Set the mode selector switch on the external machine control
panel to one of the following symbols:
JOG
INC ...
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-117
SINUMERIK 810T, GA3 (BN)