Siemens Sinumerik 810T - Manual (Page 31)

09.91 2 Operation
2.1.1 SINUMERIK 810T operator interface with integrated machine control panel
You operate this key when you want to search in a part program for:
• an address
• a block number
• a word
or when you want to display on the screen:
• a tool offset number (with the appropriate data)
• a machine data (MD) or setting data (SD).
Before operating the Search key you must write the data to be searched
for into the input line (see Section 2.1.1.1).
Upon operation of the key, the cursor (appearance / format:
)
jumps directly to the data searched for.
Please note when searching in a part program:
• Addresses (other than the N... address) and words are only
searched for from the current cursor position in the direction
of end of program.
• If the data sought is between the start of the program and the current
cursor position, it will not be marked; the ”CHARACTER NOT
FOUND” message is shown in the operator prompt line (see Section
2.1.1.1).
• Block numbers (e.g. ”N85”) are searched for and marked in both the
direction of program end and program start.
Search for address / block no. / word / calling up data
Diagnostics and start up
This switch is intended for:
• Start up
• Service
Please see the Installation Guide.
If, before entering a block number, you move the cursor to the next line
with the “+” key and the enter key, the block numbers are not displayed.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 2-15
SINUMERIK 810T, GA3 (BN)