Siemens Sinumerik 810T - Manual (Page 122)

09.91 3 Operating Sequences
3.1.5 Zero offset
STORE
Z AXIS
The zero offset is now automatically calculated by the control for the selected axes and
stored in the memory.
Input of a tool offset number D... is irrelevant for automatic tool offset. You can perform an
automatic tool offset separately as described in Section 3.1.4.4.
Enter the coordinate ascertained with the gauging
device for the ”Z axis reference plane”, and store it
using the ”STORE Z AXIS” softkey.
If required you can store the measured X coordinate
in the same way.
• • •
... ...
3.1.6 Setting data: ”R PARAMETERS”, ”SPINDLE”, ”AXIAL”, ”ANGLE
OF ROTATION”, ”SCALE MODIFICATION”
Using the setting data, you determine certain operating states.
You can input, modify or delete setting data using screen forms.
Setting data ”R PARAMETERS”
The 810T control recognizes parameters R 0 ... to R 699 and R 700 ... to R 999.
• Parameters R O...R 699 are channel-specific, i.e. they exist for all channels, ”CH1” to
”CH3”, separately.
• Parameters R 700...R 999 are jointly valid for all channels (central parameters).
Only certain R parameters are
available for the user.
The following overview shows the parameter assignment.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-23
SINUMERIK 810T, GA3 (BN)