Siemens Sinumerik 810T User Manual

Page 91

09.91

2 Operation

2.5 Glossary of softkey functions

DRY RUN YES-NO

With ”YES”, the axes are traversed at the dry run feedrate, not the programmed feedrate. The
dry run feedrate is set via setting data.

EDIT

EDIT leads to ”SELECT PROGRAM”, ”GUIDING” and ”SIMULATION”.
Editing means:

– Input of a program into the memory or changing or altering a program already in the

memory.

ENABLE

You can enable the handwheel for the selected axis with this softkey.

ETX START

Output of the end of block character (end of text)

FEED

You select the G functions for the type of feed via softkey. Preselect: softkey ”GUIDING”.

G FUNCT.

You select the G functions from groups G 0 to G 12 via softkeys (see Programming Guide).
Preselect: ”GUIDING” softkey.

GUIDING

The operator guiding (operator prompting) function speeds up and simplifies the input of part
programs.
Apart from geometric functions (G function, contour definition) you can also input machining
cycles and technological functions (feedrate, spindle speed) via softkeys.

HANDWHEEL

In the INC 1...INC 10000 operating mode you activate an electronic handwheel via softkeys.
The electronic handwheel enables operation which is equivalent to jog handwheel operation.

HW VERSION

You can display the hardware data by operating this softkey.
Preselect: DIAGNOSIS and SW VERSION softkeys.

INPUT DISPLAY

To call up the input displays with corresponding operator guidance macros configured by the
machine tool manufacturer from the user memory submodule. Please refer to the information
supplied by the machine tool manufacturer for the actual menus, display descriptions and
operating sequences.

LINE

You select the G functions for linear interpolation by means of a softkey.

2-67

SINUMERIK 810T, GA3 (BN)