Siemens Sinumerik 810T - Manual (Page 230)

3 Operating Sequences 01.93
3.2.8 ”Incremental” mode (”INC FEED 1 ... INC FEED 10 000”)
In ”Jog operation” the axis is traversed for as long as the key remains pressed. When the
key is no longer being pressed, the traversing movement is stopped - even if the set
increment has not been reached.
A machine data defines whether “Incremental” is
traversed in “Modal” or “Jog operation” mode.
The spindle speed, and T, H and M functions can be changed using ”OVERSTORE” (see
Section 3.2.3.2).
3.2.9 ”HANDWHEEL”
Using the ”HANDWHEEL” softkey function, a command pulse from a digital-incremental
encoder, connected to a handwheel, can be activated.
The increment per encoder pulse, is set as for ”Incremental” (INC ...”), however, the ”1000”
and ”10 000” values are inhibited!
For these softkey functions, and selector switch settings, the selection is limited to ”100”.
Caution! The smallest possible traversing distance is defined by the input resolution.
100
Operate the operating mode selection key on the
integrated machine control panel, and then any of
the ”INC 1” to ”INC 10 000” softkeys or...
or
... set the operating mode selector switch
on the external machine control panel to
the ” 1 ”, ” 10 ”, ” 100 ”, ” 1000 ”or
” 10 000 ” setting (”10” in example).
1
10
10 000
1 000
INC ...
Sequence of operation
3-124 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)