Siemens Sinumerik 810T - Manual (Page 257)

01.93 4 Monitoring Functions
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
2031
”Eval. (weighting) factor too high (MD 388*)”
Remarks: Alarm only on commissioning
Alarm No.
Alarm Text:
2032
”Stop during threading”
Reason:
Effect:
During thread cutting, the feed per revolution was stopped, and the
thread destroyed.
Inhibiting of NC START
Alarm No.
Alarm Text:
2034
”Speed reduction area”
Reason:
Remedy:
The software pre-limit was overshot, and the axis decelerated to the
reduced traverse rate
Check the program
Alarm No.
Alarm Text:
2035
”Feed limitation”
Reason:
Remedy:
The programmed feedrate is higher than the contouring feedrate,
based on the maximum feedrate of the axes.
Program a lower contouring feedrate
Alarm No.
Alarm Text:
2036
”G35 thread pitch decr. error”
Reason:
Remedy:
The pitch decrease in threading is so high that at the end of the thread
a diameter of less than, or equal to zero would result.
Program either a smaller pitch decrease or a shorter thread
Alarm No.
Alarm Text:
2037
”Programmed S value too high”
Reason:
Remedy: The programmed spindle speed ”S” is higher than ”16000”.
Program a smaller spindle speed (the S value is limited to ”16000”
within the control).
Alarm No.
Alarm Text:
2038
”Path feed too large”
Reason:
Effect:
Remedy: Axis velocity too great because of the programmed path velocity.
NC START disabled and setpoint relay drops out.
Observe permissible value range.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-15
SINUMERIK 810T, GA3 (BN)