7 deleting a program (”delete”) – Siemens Sinumerik 810T User Manual

Page 167

3 Operating Sequences

11.90

3.1.13 Program management

3.1.13.7 Deleting a program (”DELETE”)

Using the ”DELETE” function you can either delete each program singly, or a sequence of
programs.

Operate the ”PART PROGRAM” and ”PROGRAM
HANDLING” softkeys, one after the other, in any of
the operating modes:
PRESET / JOG / AUTOMATIC /
INC 1...INC 10 000 / REFPOINT.

All programs from ”% 2” to ”% 5” inclusive, are now deleted by the control.

Deleting a sequence of programs

Using the keyboard, enter for example, ”% 2”,
operate the ”=” key, and enter for example
”% 5”.

Operate the ”DELETE” softkey.

Deleting an individual program:

Using the keyboard, enter the desired program
number ”%...” (or ”L...”), and operate the
”DELETE” softkey.

The program entered is deleted by the control.

Note:

The memory space cleared by deletion of the programs will become available again only
after ”REORG” (see Section 3.1.13.8).

DELETE

• • •

PART
PROGRAM

PROG.-
HANDL.

...

DELETE

5
J

Sequence of operation

3-64

SINUMERIK 810T, GA3 (BN)