Siemens Sinumerik 810T User Manual

Page 239

Text mode
Original mode

3 Operating Sequences

09.91

3.2.12 ”Repositioning” mode (”REPOS”)

and

... set the operating mode selector switch on the external
machine control panel to this symbol.

Prerequisite:

You have generated a program interruption - e. g. by switching to “JOG” mode - and sub-
sequently traverse away from the contour (see Section 3.2.7 for sequence of operation).

Operate the operating mode selection key on the inte-
grated machine control panel and then the ”REPOS”
softkey or...

REPOS

Sequence of operation

This display appears on the CRT.

(( 810T))
(( Bild 9 von Druckerei

einmontieren

The red ”Feed hold” LED display is extinguished.

3-132

SINUMERIK 810T, GA3 (BN)