Siemens Sinumerik 810T - Manual (Page 204)

3 Operating Sequences 01.93
3.2.3 Influencing ”AUTOMATIC” operation
You could now modify the following data:
• Tool number T ...
• Spindle speed S ... or S1=..., S2=...
• Auxiliary function H ...
• Additional function M ... or Mn=...
Using the cursor keys, now set the inverse
marking to the desired input field.
Using the keyboard, enter the first correction
value
and store it with the input key.
Operate the ”Program start” key as soon as
you have entered all corrections.
..
.
etc.
..
.
etc.
..
.
etc.
The program now operates with these new values until a new value in the program supersed-
es the overstored function, or until you enter a new value using ”OVERSTORE”.
... ...
3-100 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)