Siemens Sinumerik 810T - Manual (Page 36)

2 Operation 11.90
2.1.1 SINUMERIK 810T operator interface with integrated machine control panel
Continuous mode:
When the direction key is pressed (whether you press for a short or long
time), the axis only traverses one increment (1/ 10/ 100/ 1000/ 10000
µ m,
depending on the setting).
Jog mode:
The axis traverses as long as you press the direction key. Traversing stops
when you release the key. This also happens if the set increment has not
been reached.
It is defined in machine data whether the axes are
traversed using the direction keys in either:
- continuous mode or
- jog mode.
Function of the direction keys
With this key you traverse the ”X” axis
With this key you traverse the ”X” axis in the opposite direction
With this key you traverse the ”Z” axis
With this key you traverse the ”Z” axis in the opposite direction
With this key you traverse the ”Q” axis (Auxiliary axis)
With this key you traverse the ”Q” axis in the opposite direction
Rapid traverse override:
When you operate this key at the same time as any of the keys above,
the axis is traversed at rapid speed.
+X
– X
+Z
– Z
+Q
– Q
The rapid traverse speed is defined in a machine data.
2-20 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)