Siemens Sinumerik 810T User Manual

Page 217

3 Operating Sequences

09.91

3.2.3 Influencing ”AUTOMATIC” operation

You stop program sequencing manually by operating the "STOP EDIT"
softkey.

End:

Program sequencing comes to a regular end as soon as the program
number 0000 is reached the first time during processing the program
sequence list.

Enter consecutive number 0, if No. 0 exists in the list and press the
search key.

Operate the "START OPS" softkey.

OPS operation is terminated (program number 0000 is reached).

As opposed to "Interruption", "End" results in the internal OPS
management being reset to its defined starting state. In the case of an
interruption, internal flags and pointers are preserved as they were at the
moment of interruption.

STOP
EDIT

START
OPS

Sequence of operation

Note:
If "STOP EDIT" is pressed while programs are being transferred (indicated by the "DIO"
screen display), it may happen that the last program loaded is incomplete in the NC memory!
Unless the "OPS mode" display is left, this has no consequences at all.
In the case of a return jump to the "Note: "OPS mode" display this can result in an error
message ("Different programs same No. (RS232C (V.24))") if the incompletely transferred file
is once again called from there.
For further details, please refer to the documents on the DSG-2S disk drive.

3-112

SINUMERIK 810T, GA3 (BN)