5 control keys – Siemens Sinumerik 810T User Manual
Page 27
11.90
2 Operation
2.1.1 SINUMERIK 810T operator interface
with integrated machine control panel
2.1.1.5 Control keys
View of the control keys
1...n
Cursor left / right movement
Cursor up/down movement
With these keys you move the cursor on the CRT.
SINUMERIK 810T differentiates between:
•
Cursor for marking a word / block within displayed
part programs
Cursor appearance / format:
•
Cursor for marking an input field within displayed input forms /
dimensioned graphics
Cursor appearance / format:
or
(Cursor length depends on the max. permitted number of characters of
the marked field)
With this key you move the cursor :
•
from word to word, to the left
•
to the end of the previous block (after the last word / in front of LF),
when the cursor is positioned before the start of the block.
With this key you move the cursor :
•
from word to word, to the right
•
before the start of the following block, when the cursor is positioned at
the end of block (after the last word / in front of LF).
Cursor movement in a part program
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
2-11
SINUMERIK 810T, GA3 (BN)