Siemens Sinumerik 810T - Manual (Page 229)

01.93 3 Operating Sequences
3.2.8 ”Incremental” mode (”INC FEED 1 ... INC FEED 10 000”)
100
Operate the operating mode selection key on the
integrated machine control panel and then any of
the ”INC 1” to ” INC 10 000” softkeys or...
or
... set the operating mode selector switch,
on the external machine control panel,
to the setting
” 1 ”, ” 10 ”, ” 100 ”, ” 1000 ”or
” 10 000 ”
(”10” in example).
By operating any direction key, you traverse the
corresponding axis.
The red ”Feed hold” LED display must not be bright
during the sequence of operation.
1
10
10 000
1 000
INC ...
– Z
– X
+X +Q
– Q
+Z
Sequence of operation
Notes:
The direction keys can perform in two different ways:
• ”Modal”
• ”Jog operation”
When ”Modal” the axis is always traversed by one increment, in accordance with the setting
(1, 10, 100, 1000, 10 000 increments), when the key is pressed (irrespective of whether the
key is pressed for a short or long time).
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-123
SINUMERIK 810T, GA3 (BN)