Siemens Sinumerik 810T - Manual (Page 164)

3 Operating Sequences 11.90
3.1.13 Program management
3.1.13.5 Moving a program (”MOVE”)
Using the ”MOVE” function, you can move the program selected to the end of the memory.
While another program is being processed, only the program at the end
of the memory can be modified.
Operate the ”PART PROGRAM” and
”PROGRAM HANDLING” softkeys, one after the
other, in any of the operating modes:
PRESET / JOG / AUTOMATIC /
INC1... ICN10 000/ REFPOINT
Using the keyboard, enter the desired program no.
”%...” (or ”L...”), and operate the ”MOVE” softkey.
PART
PROGRAM PROG.-
HANDL.
• • •
MOVE
...
%
Sequence of operation
The program selected is moved to the end of the memory.
Note:
If the cycle lock has been cancelled by the PLC you can copy a cycle from the EPROM to the
end of the program memory with the ”MOVE” function. You can then edit the cycle like a
normal part program.
As the cycle now exists twice under the identical no.L (in the EPROM and the program
memory), the cycle in the EPROM is marked in the directory with an (*). The cycle in the
program memory has priority on selection.
The cycle in the EPROM can be called again with the ”SELECT PROGRAM” softkey, when
the respective cycle has been deleted from the program memory.
3-62 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)