Siemens Sinumerik 810T User Manual

Page 200

11.90

3 Operating Sequences

3.2.3 Influencing ”AUTOMATIC” operation

Note:

The ”Single block” (see Section 2.1.1.6) function works in a similar way.

Operating this key activates the ”Single block” function. The
generated signal is active at the end of the (current) block being
processed.
The ”SBL” (Single block) display appears in the first line of the CRT
display.

Operating the ”Program start” key, causes the single block to be
processed.

The following table indicated in which blocks the ”Decoding single block active” signal, or the
”Single block active” signal must be present if a program is to be processed on a block-
by-block basis.

•

Blocks which have been ”pre-processed” without the ”Decoding single block” signal
present in the buffer memory - that have not yet been processed - cannot be stopped.

•

A ”Decoding single block” can be influenced using ”OVERSTORE” (see Section
3.2.3.2).

Single block

Block type

Traversing block

Decoding single

block

Block

without path information

Calculation block

Switching and auxiliary function block

Internally generated control block (CRC ...)

Threading block without dry run feedrate

Threading block with dry run feedrate

= ”Single block” or ”Decoding single block” signal is required.

3-97

SINUMERIK 810T, GA3 (BN)