Siemens Sinumerik 810T User Manual
Page 276
01.93
4 Monitoring Functions
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
3201
”Spindle not synchronous”
Reason:
Remarks:
•
Rotary axis operation has been initiated even though the spindle is
not synchronous.
Turn spindle again until it is synchronous.
Alarm No.
Alarm Text:
4100
”No D number active”
Comment:
Cycles alarm
Alarm No.
Alarm Text:
4101
”Cutter radius = 0”
Comment:
Cycles alarm
Alarm No.
Alarm Text:
4102
”Cutter radius too large”
Comment:
Cycles alarm
Alarm No.
Alarm Text:
4103
”Tool too wide”
Comment:
Cycles alarm
Alarm No.
Alarm Text:
4104
”ZO data block number not allowed”
Comment:
Cycles alarm
Alarm No.
Alarm Text:
4105
”Direction of spindle rotation not programmed”
Comment:
Cycles alarm
Alarm No.
Alarm Text:
6000
to
6063
See explanation
Explanation:
These PLC error messages are set by the machine tool manufacturer
(see machine tool manufacturer's documentation)
Alarm No.
6100
to
6163
Explanation:
Alarms only on commissioning
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
4-33
SINUMERIK 810T, GA3 (BN)