Siemens Sinumerik 810T - Manual (Page 298)

09.91 7 Interfacing to the Machine
7.3.4 Definition of the initial setting of the G groups
7.3.4 Definition of the initial setting of the G groups
Previously the initial settings for the G groups 0/2/3/5/7/9/10/11 and 13 were defined
permanently (For G group allocation see Section 12).
Now you can define the initial setting of
G groups 0/2/5/7 and 11
channel-specifically. Simply enter the number of the G function you want to be the
initial setting in the channel data.
Exception:
The initial setting G70/G71 is still entered in machine data 5002, bit 4.
A display with the channel-specific machine data MD 1000 to 1019 appears.
Use the “page down” key to page through the display until the machine data up to 1199
appear. Now you can enter the initial settings of the above G groups directly into MD 108*
to 118* (2nd steps).
Four input fields are available to you. In the first two (from left to right) of each you define
the channel-specific (1st and 2nd channel) initial setting of the G group assigned to the
machine data.
Inputs in other input fields cause the alarm message “General data error”. The allocation of
NC MDs to G groups or G functions are to be found in the overview on the next page.
Sequence of operation
CHANNEL
DATA
DIAG-
NOSIS
NC MD
Press the “DIAGNOSIS” softkey.
Extend the menu displayed with the ETC key and press the
“NC MD” softkey.
Extend the softkey menu again and press the “CHANNEL
DATA” softkey again.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 7-9
SINUMERIK 810T, GA3 (BN)