Siemens Sinumerik 810T - Manual (Page 119)

3 Operating Sequences 09.91
3.1.5 Zero offset
3.1.5.2 Programmable zero offset
- external zero offset
a) Programmable zero offsets
The values for the G58 and G59 offsets can be written in the program.
You will find information on the programming of these zero offsets in Part 2,
“Programming”, Section 2.5.
The programmed zero offset for the current part program % ... can be displayed.
Precondition:
You have selected the ”AUTOMATIC” operating mode, with the operating mode selector
switch, symbol and have called a program % ...
Now operate the ”SETTING DATA” softkey ...
SETTING
DATA
PROG.
ZO
... and then the ”PROGRAMMABLE ZERO OFFSET” softkey.
Sequence of operation
This display appears.
You can now read the values for
“G58” and “G59” for the axes X and Z
axes (Q1,Q2,.., if present), but you
cannot change them.
((Bild 810T/19 einmontieren))
3-20 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)