Siemens Sinumerik 810T - Manual (Page 109)

3 Operating Sequences 11.90
3.1.4 Tool offset
3.1.4.3 Deleting all offset values in an
offset number D ...
a) You would like, for example, to delete all values stored under tool offset number ”D5”.
Using the key you enter ”5”.
You operate the ”Delete word/block” key.
When you now select the tool offset number ”D5”, using either the ”Page up/down”
keys , or by entering the number ”5” and operating the search key , you
can check that all the values in this offset number have been set to ”zero”.
5
J
Sequence of operation
b) You would like, for example, to delete all stored values under tool offset numbers ”D4” to
”D9”.
Using the keys you enter ”4 = 9”.
You operate the ”Delete word/block” key.
When you now call the tool offset numbers ”D4” to ”D9”, as described in a) above, you can
check that all offset values have been set to ”zero”.
4
L
=
H
9
Z
Sequence of operation
3-10 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)