Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual User Manual
Page 472
Troubleshooting
F–10
Publication 2711-6.0
Errors and Informational Messages from RNA.EXE
This message occurs normally at shutdown.
RNA removed from memory.
This parameter for the -b argument (indicating number of solicited
message buffers to use) given on the command line for RNA.EXE
was out of allowed message range of 1 to 40. A default of 20
solicited buffers will be used.
RNA: -b must be 1-40, using default of 20
The format of the options given on the command line for RNA.EXE
were invalid. Correct the option(s) and start RNA.EXE again.
RNA: illegal option ––
RNA: invalid option
RNA: invalid option (option); must begin with ‘–’
RNA: option requires an argument ––
The number of packet buffers,
line cannot be created. If your buffers were loaded into upper DOS
memory (the default), your upper DOS memory may be full.
Specify -e0 on the RNA.EXE command line to force the buffers to
use low DOS memory.
RNA: ERROR – cannot create
The number of unsolicited buffers,
command line cannot be created. If your buffers were loaded into
upper DOS memory (by no additional command line options), it may
be full. Specify -e0 on the RNA.EXE command line to force the
buffers to use low DOS memory.
RNA: ERROR – cannot create
The RNATSR was loaded from DOS. It cannot be uninstalled with
Windows running. Exit to DOS to uninstall the RNATSR.
RNA: RNATSR loaded before Windows, cannot uninstall from Windows
Other TSRs have been installed after the RNATSR. They must be
removed from memory before the RNATSR can be uninstalled.
RNA: Cannot uninstall RNATSR; not at end of INT 2F chain
The RNATSR must be installed before running RNA.EXE.
RNA: RNATSR is not installed.