Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 15)

Preface P–3
Publication 2711-6.0
The following conventions are used throughout this manual:
•
PanelBuilder refers to the PanelBuilder Configuration Software.
•
PanelView or terminal refers to any one of the PanelView
terminals unless specifically stated.
•
Windows refers to Windows 95, Windows NT, or Windows 3.1 or
higher.
•
Keys on the keyboard appear in small capital letters. For
example, the Ctrl key appears as
CTRL in the text, the Alt key as
ALT, and so on.
•
When keys are to be pressed in combination, you’ll see them
connected by a +. For example,
ALT+F4 means hold down the ALT
key while you press F4.
•
Procedures begin with bold text followed by a semicolon.
To open an application file:
•
A solid right cursor in the left margin indicates a tip or hint.
Anchor point is the handle opposite the handle you choose. The
anchor point doesn’t move when sizing objects.
The following table lists publications related to the PanelBuilder
Configuration Software and the PanelView Operator Terminals.
Publication Title Publication No.
PanelView Terminal User Manual 2711-6.1
PanelBuilder Getting Started Manual 2711-6.2
DeviceNet Communications for PanelView Terminals 2711-6.0.4
ControlNet Communications for PanelView Terminals 2711-6.10
PanelView File Transfer Utility 2711-805
For information relating to your logic controller, INTERCHANGE
or RSLinx Lite Software, or Microsoft Windows, refer to the
appropriate documentation.
Conventions
"
Related Publications