Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 394)

23–6 Validating and Transferring Applications
Publication 2711-6.0
You can transfer applications between a computer running
PanelBuilder and one of the following:
•
PanelView terminal
•
Memory card
•
DOS file
PanelView Terminal
Direct Connection
Downloads applications from the RS-232 connection on your
computer or workstation. For connection details, see Publication
2711-6.1.
Use the Internal DF1 Driver to transfer applications directly to a
PanelView terminal using the terminal’s RS-232/DF1 port.
To transfer an application directly to a DH-485 or RS-232 (DH485
protocol) terminal using the 1747-PIC converter, you must configure
the 1747-PIC driver using RSLinx or INTERCHANGE software.
DH+ Local Connection
Downloads applications from a computer or workstation on the
Allen-Bradley Data Highway Plus

(DH+) link to a DH+
PanelView terminal on the link. For connection details, see
Publication 2711-6.1.
A DH+ RSLinx or INTERCHANGE driver must be installed on the
computer.
Pass-Through Connection
Pass-Through lets you transfer applications between a computer or
workstation on a DH+ link and a terminal on a Remote I/O link or
DH-485 link. Data passes through a controller, which is a bridge
between the two networks. For connection details, see Publication
2711-6.1.
A DH+ RSLinx or INTERCHANGE driver must be installed on the
computer.
Transfer Options