Drawing connected lines – Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual User Manual

Page 258

16–4

Adding Graphics

Publication 2711-6.0

Use the Connected Line command or tool to draw open connected
lines or shapes such as triangles and other simple polygons.

To draw connected lines:

1. Click the Connected Line tool in the toolbox.

Or choose Connected Line from the Objects

Graphics submenu.

2. Position the pointer (+) where you want to anchor one end of the

first line and click the left mouse button.

3. Move the pointer where you want to end the line and start the

next line, and click the left mouse button.

You can adjust the position of the line before clicking.

4. Repeat step 3 for each line you want to draw.

5. After drawing the last line, double-click.

6. Click the right mouse button to exit connected line mode.

Or click the selection tool on the toolbox.

Drawing Connected Lines