Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 151)

9–11 Creating Control List Selectors
Publication 2711-6.0
Editing State Text
The Text field defines the text that will appear for each state in the
Control List Selector. Double-click the cell and edit the text.
Other text fields control how the text is formatted for each state:
•
text size (selection applies to entire list)
•
underline
•
text blink
•
alignment (left, right, center)
•
foreground color
Entering State Values
If Value was selected on the Properties tab, the Value field appears
for each state. This field specifies a numeric value to send to the
word address for each state. The default value is the state number.
The value you enter must be within the range of the Data Format
selected on the Properties tab. The default value is the state number.
Data Format Range
Binary➀ 0000 0000 0000 0000 to 1111 1111 1111 1111
Unsigned Integer 0 to 65535
Signed Integer -32768 to +32767
4-BCD 0 to 9999
Hexadecimal➀ 0 to FFFF
Octal➀ 0 to 177777
➀ Formats allowed for data entry. The terminal does not display/transfer these formats.
The value is converted when a different data format is selected.
Restricting Access to States (Piloted Control Lists only)
The Access field appears only for Piloted Control Lists. This field
allows you to specify who can access the control list state.
Select To
User and Controller Allow the operator and controller to select the control list state.
User Only Allow only the operator to select the control list state.
Controller Only Allow only the controller to select the control list state.
None Create an inactive state.
Important: Do not select “Controller Only” or “None” for the
initial state defined on the States tab. These settings will
result in a validation error. One state must allow user
access or the application will fail to validate