Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 384)

22–14 Multilingual Support
Publication 2711-6.0
Step 4 – Copy Font File to Memory Card
To run the application on the PanelView terminal, the font file must
reside on a memory card loaded in the terminal.
To copy a font file to an ATA flash card:
(Catalog No. 2711-NM22, -NM24, -NM26)
•
In FontTool, choose Save to Memory Card from File menu.
•
In PanelBuilder, choose Copy Font File from File menu.
•
In the Application File Transfer Utility, download an .OTF file to
a DOS memory card. Click the Setup button to enter a COPY
command, for example:
copy \ab\pbwin\font\china_s.otf m:
where the file china_s.otf is copied to memory card drive m:
•
In DOS, use the COPY command as shown above.
To save a font file to a flash memory card :
(Catalog No. 2711-NM11, -NM12, -NM13, -NM14)
•
In the Application File Transfer Utility, you can download a
specific .OTF file to a DOS memory card. Click the Setup button
to enter the appropriate command string to download the file.
See page 23–17 for details on the command string.
•
In DOS, use the appropriate command string to copy the file to a
memory card. See page 23–17 for details on the command string.
Step 5 – Download and Run the Application
To run a PanelBuilder application using a font file:
•
download the PanelBuilder application to a PanelView terminal.
•
insert the memory card, containing the font file, in the card slot
on the PanelView terminal.
•
use the memory card retainer (Catalog No. 2711-NMCC,
-NMCD) to prevent accidental removal of the card from card slot.
Important: The application will not run properly unless the
memory card containing the font file is inserted in the
PanelView terminal.