Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 469)

Troubleshooting F–7
Publication 2711-6.0
The indicated command or parameter in CFG_KT.INI is invalid.
Correct your CFG_KT.INI file and restart the INTERCHANGE
Software.
CFG_XXX (0007) TSR not configured, invalid line;
CFG_XXX (0008) TSR not configured, invalid parameter;
CFG_XXX (0009) TSR not configured, invalid ‘memory’ parameter
CFG_XXX (000a) TSR not configured, invalid ‘interrupt’ parameter
Not enough memory was available to configure the DTL_KT TSR.
Obtain more free memory on your computer and restart the
INTERCHANGE Software.
CFG_KT (000b) TSR not configured, unable to allocate memory
An error occurred when configuring the DTL_XXX TSR. The
DTL_XXX TSR may already be running. Shut down and restart the
INTERCHANGE Software to correct the problem.
CFG_XXX (000c) TSR not configured, ‘TSR’ parameter already in use
CFG_XXX (000d) TSR not configured, no KT(s) could be initialized
Commonly caused by one of the following:
1. no communication cards are specified in CFG_KT.INI.
2. the software or hardware setting of the memory address for your
communication card does not match that entered in the
CFG_KT.INI file.
3. the environment variable ABIC_CONFIG, points to a location
which has an invalid or nonexistent CFG_KT.INI file.
The executable CFG_XXX.EXE has previously been run to
configure the DTL_XXX TSR. It is not necessary to run
CFG_XXX.EXE again, however, it has caused no harm to do so.
CFG_XXX (000e) TSR already configured, no action taken
Your installation may have been unsuccessful. Re-install the
INTERCHANGE Software and restart the INTERCHANGE
Software. If this error still occurs, contact your Rockwell Software
Inc. Global Technical Support Representative.
CFG_XXX (000f) TSR version is incompatible with this executable
CFG_XXX (0010) TSR not found, must first be resident to be configured
Caused by one of the following: