Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 127)

7–19 Working with Objects
Publication 2711-6.0
You can hide the view of an object to reduce the number of objects
on a screen. Only input objects assigned to a function key or touch
cell can have the view turned off. These objects are:
•
Push button controls
•
Screen selector buttons
•
Keypad enable button
When the view is off, the object isn’t displayed. However, the
object’s function key or touch cell is still active.
!
ATTENTION: When turning off the view of a touch
cell object, you must place a graphic on that area of the
screen. Otherwise, an operator could inadvertently
touch that screen area and activate the function.
To hide the view of an object:
1. Click the Options tab from the dialog of the selected object.
2. Click the Turn Object View On box to show the object view.
When the view shows, the box contains an X. To hide the view,
clear the check box.
3. When done, click OK to exit the dialog.
Hiding an Object