Ramp function generator for angle signals (rfgph1), Function library, Function blocks – Lenze EVS9332xK User Manual
Page 298: Range of functions

Function library
Function blocks
3.2.85
Ramp function generator for angle signals (RFGPH1)
3−270
l
EDSVS9332K−EXT EN 4.0
3.2.85
Ramp function generator for angle signals (RFGPH1)
Purpose
Path or time controlled (jump) application to change position/angle (e.g. offset) relative to the master
drive.
RFGPH1
RFGPH1-IN
RFGPH1-RESET
RFGPH1-RFG-I=0
C1400/1
C1402/1
C1403/1
C1401/1
RFGPH1-T/DIST
C1400/2
C1401/3
RFGPH1-DFIN
C1404/1
C1405/1
CTRL
RFGPH1-DIST
C1402/2
C1403/2
RFGPH1-OUT
RFGPH1-IN-OLD
RFGPH1-RFG-0
C1400/3
C1401/2
fb_rfgph1
Fig. 3−221
Ramp function generator for phase signals (RFGPH1)
Signal
Source
Note
Name
Type
DIS
DIS format
CFG
List
RFGPH1−RESET
d
1401/1
bin
1400/1
2
HIGH: Sets RFGPH1−OUT = 0 (jump)
LOW : RFGPH1−OUT is set to the value at RFGPH1−IN according to
the selected function
Input has priority over RFGPH1−RFG−0
RFGPH1−RFG−0
d
1401/2
bin
1400/2
2
HIGH : proceeds according to the selected function RFGPH1−OUT =
0
LOW : RFGPH1−OUT is set to the value at RFGPH1−IN according to
the selected function
RFGPH1−T/DIST
d
1401/3
bin
1400/3
2
Function changeover
HIGH: Path based change
LOW: Time−based change in path (position via defined speed)
RFGPH1−IN
ph
1403/1
dec [inc]
1402/1
3
Position setpoint (65536 inc. = 1 rev.)
RFGPH1−DIST
ph
1403/2
dec [inc]
1402/2
3
Path difference by which the phase is to be changed at the input
RFGPH1−IN (65536 inc. = 1 rev.)
·
Condition for accepting the value at RFGPH1−DIST:
– RFGPH1−OUT = 0
or
– the value at the RFGPH1−IN input is changing.
RFGPH1−DFIN
phd
1405/1
dec [inc]
1404/1
4
Digital frequency input
Please observe that the modes to be set for this input are selected
under C1409 (see "Phase/position to be changed through a defined
path")
RFGPH1−RFG−I=0
d
−
−
−
HIGH: RFGPH1−OUT = RFGPH1−IN
RFGPH1−OUT
ph
−
−
−
Output
RFGPH1−IN−OLD
ph
−
−
−
Display of the value (65536 inc. = 1 rev.) last−applied at the input
RFGPH1−IN
Range of functions
l
Change phase/position through a defined speed (chapter 3.2.85.1)
l
Change phase/position through a defined path (chapter 3.2.85.2)
l