Canon imageCLASS MF7470 - Manual (Page 83)

1
2
3
4
5
6
7
8
9
10
11
3-12
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
6. Press (Start).
To return the copy ratio to 100%, press [Direct].
To cancel all settings and return the machine to the Standard
mode, press (Reset).
Auto Zoom
You can set the machine to automatically select the appropriate
copy ratio based on the size of the original and the selected copy
paper. The same copy ratio is used for the horizontal (X) and vertical
(Y) axes. The available copy ratios are from 50% to 200%.
You cannot use the Auto setting on the Copy Ratio screen with the
Automatic Paper Selection mode.
You cannot copy highly transparent originals, such as transparencies,
using the Auto setting on the Copy Ratio screen. Use the Preset Zoom or
Zoom by Percentage mode instead.
To use the Auto setting on the Copy Ratio screen, your originals must
conform to one of the standard paper sizes:
11" x 17", LGL, LTR, LTRR, STMT or STMTR (You can only place an STMTR
original on the platen glass.)
1. Press (COPY) .
2. Place your originals.
3.
Press [Paper Select].
–
–
–
–
–
–
4. Select the desired paper size , then press [Done].
Make sure that you select a paper size other than [Auto]. If you do
not select a paper size, the copy ratio is automatically set to match
the size of the paper loaded in Paper Drawer 1.
5. Press [Copy Ratio].
6. Press [Auto], then [Done].
7.
Press (Start).
To return the copy ratio to 100%, press [Direct].
To cancel this setting, press [Copy Ratio], then [Auto].
To cancel all settings and return the machine to the Standard
mode, press (Reset). –
–
–