Canon imageCLASS MF7470 - Manual (Page 104)

1
2
3
4
5
6
7
8
9
10
11
3-33
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
6. Select the key containing the copy settings that
you want to erase , then press [Next].
Make sure to check the settings first before erasing them.
Keys that already have settings stored in them are displayed with
a black square (
■) in the lower right corner of the key.
If you select a key that already has settings stored in it, the
settings are displayed.
If there are more stored copy settings than are currently
displayed, you can scroll through the list by pressing [
▼] or [▲].
7. Press [Yes].
The message appears for approximately two seconds on
the touch panel display.
The stored copy settings are erased.
To cancel erasing the settings, press [No].
Key names are not erased. For instructions on changing a key name,
see “Naming a Memory Key,” on p. 3-31.
8. Press [Cancel].
9. Press [Done].
When a memory key is not in use, as is the case when you delete its
settings, [OK] is grayed out, and you must press [Cancel] → [Done] to
complete the procedure.
–
–
–
–