Canon imageCLASS MF7470 - Manual (Page 170)

1
2
3
4
5
6
7
8
9
10
11
4-59
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
3. Select the destination to be erased, then press
[Erase].
You cannot erase multiple destinations at the same time.
Press the alphanumeric keys (e.g., [ABC]) to display the individual
keys for each letter or number. You can select a letter or number
to restrict the displayed range of entries. Press [All] to return to
the full address list.
If the desired destination is not displayed, press [
▼] or [▲] to
scroll to the desired destination.
You can restrict the type of destinations displayed in the results
list by pressing the Type drop-down list.
You can select a destination and press [Details] to confirm the
detailed information related to the selected destinations. Press
[Done] to return to the previous screen.
If you select [All] in the Address Book drop-down list, the
destinations stored in the one-touch buttons are displayed.
However, you cannot erase these destinations. For instructions
on erasing one-touch buttons, see “Erasing One-Touch Buttons,”
on p. 4-59.
4.
Press [Yes].
To cancel erasing, press [No].
The message appears for approximately two seconds on
the touch panel display.
5.
Press [Done] repeatedly until the Send Basic
Features screen appears.
–
–
–
–
–
–
Erasing One-Touch Buttons
1. Press (Additional Functions).
2.
Press [Address Book Settings] → [One-touch
Buttons].
If a password has been set for the Address Book, enter the password
using
– (numeric keys), then press [OK] to enter the Address
Book Settings menu. (See “Setting a Password for the Address Book,”
on p. 8-16.)
The Register One-touch Button screen appears.
3.
Select a one-touch button containing the
destination(s) you want to erase, then press
[Erase].
If the desired one-touch button is not displayed, press [ ▼] or [▲]
to scroll to the desired one-touch button.
You can also specify the one-touch button’s number by entering
the three digit number of the desired one-touch button using
– (numeric keys).
Make sure that you verify the settings first before you erase them.
One-touch buttons that already have destinations stored in them
are displayed with a black square (
■) in the lower right corner of
the key.
If you select a one-touch button that already has destinations
stored in it, the destinations are displayed.
If you register multiple destinations as a group address in a one-
touch button, the number of destinations registered in the group
address is displayed.
4.
Press [Yes].
To cancel erasing, press [No].
The message appears for approximately two seconds on
the touch panel display.
–
–
–
–
–
–