Canon imageCLASS MF7470 - Manual (Page 108)

1
2
3
4
5
6
7
8
9
10
11
3-37
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Changing the Current Standard Settings
The Standard Settings refer to a combination of copy modes
that the machine automatically returns to after the power is
turned on, or when (Reset) is pressed.
The Standard Settings can be changed to suit your needs, or
restored to their default settings.
Storing New Standard Settings
You can store your own copy settings as the Standard Settings.
To store your own standard settings, specify the desired settings on
the Copy Basic Features screen and/or the Special Features screen,
and then follow the procedure below.
1. Press (Additional Functions).
2.
Press [Copy Settings] → [Standard Settings].
The Standard Settings screen appears.
3. Press [Store].
■
4. Press [Yes].
The message appears for approximately two
seconds on the touch panel display.
The displayed settings are stored as the Standard Settings.
To cancel storing the currently displayed settings as the Standard
Settings, press [No].
The settings displayed are the currently set copy settings. Press [ ▼]
or [ ▲] to display any copy settings that do not fit into the display
area.
5.
Press [Done] repeatedly until the Copy Basic
Features screen appears.
Initializing Standard Settings
You can restore the Standard Settings to their default settings.
1. Press (Additional Functions).
2.
Press [Copy Settings] → [Standard Settings].
The Standard Settings screen appears.
3. Press [Initialize].
4.
Verify the settings, then press [Yes].
The message appears for approximately two seconds
on the touch panel display.
The Standard Settings are initialized.
To cancel initializing the Standard Settings, press [No].
5. Press [Done] repeatedly until the Copy Basic
Features screen appears.
■