Canon imageCLASS MF7470 - Manual (Page 248)

1
2
3
4
5
6
7
8
9
10
11
6-47
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Checking Network Connection
You can check if the network connections are properly set.
IPv4
1.
Press (Additional Functions).
2. Press [System Settings] → [Network Settings] →
[TCP IP Settings] → [IPv4 Settings] → [PING
Command].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The PING Command screen appears.
3.
Enter the desired IPv4 address existing on the
network using – (numeric keys), then press
[Start].
If you set the startup time of the machine’s network function by
following the procedure in “Startup Time Settings,” on p. 6-45,
execute the PING command only after the time set as the startup
time passes.
If you connect the machine to a switching hub, the machine
may not be able to connect to a network even though your
network settings are appropriate. This problem may be resolved
by delaying the startup of network communications for the
machine. See “Startup Time Settings,” on p. 6-45 for information
on how to set up the startup time.
4. Press [Done] repeatedly until the Additional
Functions screen closes.
■
–
–
IPv6
1. Press (Additional Functions).
2.
Press [System Settings] → [Network Settings] →
[TCP IP Settings] → [IPv6 Settings] → [ ▼] →
[PING Command].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The PING Command screen appears.
3. Check the following.
Press [IPv6 Address], enter the desired IPv6 address existing on
the network, press [OK], then [Start].
Press [Host Name], enter the machine’s host name, press [OK],
then [Start].
If you set the startup time of the machine’s network function by
following the procedure in “Startup Time Settings,” on p. 6-45,
execute the PING command only after the time set as the startup
time passes.
If you connect the machine to a switching hub, the machine
may not be able to connect to a network even though your
network settings are appropriate. This problem may be resolved
by delaying the startup of network communications for the
machine. See “Startup Time Settings,” on p. 6-45 for information
on how to set up the startup time.
4. Press [Done] repeatedly until the Additional
Functions screen closes.
■
–
–
–
–