Canon imageCLASS MF7470 - Manual (Page 36)

1
2
3
4
5
6
7
8
9
10
11
1-8
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Main Power and Control Panel Power
The machine is provided with two power switches, a main
power switch and a control panel power switch.
How to Turn On the Main Power
This section explains how to turn on the main power.
1. Make sure that the power plug is firmly inserted
into the power outlet.
Do not connect or disconnect the power cord with wet hands, as this
may result in electrical shock.
2. Press the main power switch to “I” side.
The main power indicator on the control panel lights and the screen
below is displayed until the machine is ready to scan.
■
When the machine is ready to scan, the screen below is displayed.
The example shown below is the Copy Basic Features screen.
If the main power indicator does not light, make sure that the
power cord is firmly inserted into the power outlet.
If the message the numeric keys.> or appears
on the touch panel display, enter your registered ID and
password. (See “Department/User ID Management,” on p. 1-14.)
If you want to turn the main power off, first turn the control
panel power switch off, and then press the main power switch to
the “ ” side.
If you turn off the main power, wait at least 10 seconds before
turning the main power back on.
Do not turn the main power off if you want to be able to send or
receive fax/I-fax documents. Sending or receiving fax/I-fax
documents cannot be done when the main power is turned off.
If User ID Management is set to [On], the machine will take
longer to become ready to scan.
You can set the initial screen (the first screen that appears when
the machine is turned on) from the Additional Functions screen.
The initial screen can be the Copy, Send, Scan, or System Monitor
screen. (See “Common Settings,” on p. 11-5.)
The machine will enter the Sleep mode if the main power switch
is pressed when the machine’s power is on and a certain type of
optional equipment is connected. –
–
–
–
–
–
–
–