Canon imageCLASS MF7470 - Manual (Page 66)

1
2
3
4
5
6
7
8
9
10
11
2-18
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Setting Paper Size and Type
When you place other sizes and/or types of paper, follow this
procedure to change the settings.
Setting Paper Type for the Paper Drawers
This setting enables you to specify the paper type loaded in each
paper source.
Once you specify this information, icons indicating the type of
paper loaded in each paper source appear on the paper select
screen.
Be sure to correctly set the paper type. If the type of paper is not set
correctly, it could adversely affect the quality of the image. Moreover, the
fixing unit may become dirty and require a service repair, or the paper
could jam.
1. Press (Additional Functions).
2. Press [Common Settings] → [ ▼] → [Register
Paper Type].
The Register Paper Type screen appears.
3. Select the paper source in which you want to
register the paper type.
The numbers on the screen represent the following paper sources:
Paper Drawer 1
Paper Drawer 2
■
4. Select the desired paper type loaded in the
paper source, then press [OK].
Make sure that the registered paper type setting is the same paper
type that is loaded in the paper source.
5. Press [Done] repeatedly until the Basic Features
screen appears.
The registered paper type information is displayed through the use
of icons on the paper select screen, as shown below.