Canon imageCLASS MF7470 - Manual (Page 154)

1
2
3
4
5
6
7
8
9
10
11
4-43
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
8. Press [RX Start] if you require a faxed copy of the
information.
If you do not require a faxed copy of the information, press [End].
Checking Dialing Line
Checking dialing line function enables you to configure the setting
on whether to check for a dial tone.
1.
Press (Additional Functions).
2. Press [Communications Settings] → [TX
Settings] under → [Check Dial
Tone Before Sending].
The Check Dial Tone Before Sending screen appears.
3. Select [On] or [Off], then press [OK].
The Check Dial Tone Before Sending mode is enabled only after you
restart the machine (the main power switch is turned off, then back
on again).
4. Press [Done] repeatedly until the Send Basic
Features screen appears.
Dialing an Overseas Number (With Pauses)
When you dial or register an overseas number, you may need to
insert a pause within the number.
1.
Press (SEND).
2. Place your originals.
■
■
3. Enter the international fax number, then press
[Pause].
Example:
International Dialing Code: 010
Country code: 1
Area code: 516
Fax number: XXX-XXXX
[Pause]: Enter the pause time equivalent in length to the time
required for the dial tone to be heard after dialing is completed.
[Backspace]: Press when a wrong number is entered. The number
immediately to the left of the cursor is deleted, enabling you to enter
the correct number.
The pause time differs in length, depending on whether it is
entered in the middle or end of a fax number.
The pause time entered in the middle of a fax number (lower-
case p) can be changed to any number between 1 and 15
seconds. (See “Pause Time,” on p. 11-14.)
The pause time entered at the end of a fax number (upper-case
P) is set to 10 seconds long. (This length cannot be changed.)
Two or more pauses can be entered consecutively.
The location of a pause and the actual pause time may differ
depending on the telephone system. Contact your local
authorized Canon dealer or your local telephone company for
further details.
4. Press [OK].
–
–
–
–
–
–
–
–
–