Canon imageCLASS MF7470 - Manual (Page 272)

1
2
3
4
5
6
7
8
9
10
11
7-23
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
User ID registration screen
User ID: Enter a log-on name (32 characters
maximum).
Set Password: Select this check box to set a password
for the User ID.
Password: Enter a character (32 characters
maximum).
Confirm: Enter the password again. If the character
you enter here is different from the
character entered for [Password], an error
dialog box appears.
Department ID: Enter the Department ID number the
user belongs to (seven digits maximum).
If the Department ID Management mode
is set, be sure to assign the user to a
department. Otherwise, the user cannot
log on to the machine.
Set Password: Select this check box to set a password
for the Department ID.
Password: Enter a number (seven digits maximum).
Confirm: Enter the password again. If the number
you enter here is different from the
number entered for [Password], an error
dialog box appears.
User Type: Classify the user in two categories [User]
(End-User Mode) or [Administrator]
(Administrator Mode).
Display Name: Enter the user name.
E-mail Address: Enter the e-mail address of the user.
If User Management is enabled, [Display Name] and [E-mail Address]
registered above are displayed in the from field on the e-mail
recipient’s machine, instead of the unit name registered in
Communications Settings.