Canon imageCLASS MF7470 - Manual (Page 53)

1
2
3
4
5
6
7
8
9
10
11
2-5
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Loading Originals
Place your originals on the platen glass or into the feeder,
depending on the size and type of the original, and the scan
modes that you want to use.
Platen Glass
Place the originals on the platen glass when scanning bound
originals (such as books and magazines), heavyweight or
lightweight originals, and transparencies.
Feeder
Place the originals into the feeder when you want to scan several
originals at the same time, and press (Start). The machine
automatically feeds the originals to the scanning area and scans
them. Two-sided originals can also be automatically turned over
and scanned as two-sided originals.
Original Sizes
The size of the original is automatically detected, and the document
is scanned. If the output paper in the recipient’s machine is not
equal to the scanned size, the original image may be reduced in size
or divided into smaller parts before it is sent.
The machine cannot always detect the size of the original if it is a
nonstandard paper size, such as a book. In this case, specify the size
at which you want to scan the original. (See “Document Size,” on
p. 4-15.)
●
●
■
Orientation
You can place an original either vertically or horizontally. Always
align the top edge of your original with the back edge of the platen
glass (by the arrow in the top left corner) or the back edge of the
feeder.
Platen Glass
Vertical Placement Horizontal Placement
Feeder
Vertical Placement Horizontal Placement
■