Canon imageCLASS MF7470 - Manual (Page 241)

1
2
3
4
5
6
7
8
9
10
11
6-40
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
6. Press [Port Number].
7.
Enter the port number of a proxy server using
the – (numeric keys).
8. Select [On] or [Off] for
Same Domain>.
9.
Press [Authentication Settings].
10. Select [On] or [Off] for
Authentication>.
[Off ]: Disables the use of proxy authentication. Skip to step 15.
[On]: Enables the use of proxy authentication. Proceed to step 11.
11. Press [User].
12.
Enter the user name to use for proxy
authentication, then press [OK].
13. Press [Password].
14. Enter the password to use for proxy
authentication, then press [OK].
15. Press [OK].
16. Press [OK].
17. Press [Done] repeatedly until the Additional
Functions screen closes.
18. Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.
TCP/IP Settings (IPv6)
You cannot use the functions of IPv6 without using the functions of IPv4.
IP Address Settings
The machine can use up to seven of the following IPv6 addresses.
With IPv6 communication, multiple IPv6 addresses can be used at
the same time.
Link local address (1)
An address that is only valid within the same link. A link local
address is automatically set using a specific prefix (fe80::) and an
interface identifier generated from the MAC address of the
machine. When the machine is using the functions of IPv6, one link
local address is always registered.
Manual address (0 or 1)
A fixed address that is set from the control panel.
Stateless address (0 to 6)
A stateless address is automatically set using the machine’s MAC
address and the prefix (information indicating the network
belonged to) included in the RA (Router Advertisement) notified by
the router when the machine is started.
Stateful address (0 or 1)
A stateful address can be obtained from a DHCP server using
DHCPv6.
■
●
●
●
●