Canon imageCLASS MF7470 - Manual (Page 102)

1
2
3
4
5
6
7
8
9
10
11
3-31
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
5. Press [Store/Erase].
6.
Press [Store].
7. Select a key ([M1] to [M4]) for storing the copy
settings, then press [Next].
Keys that already have settings stored in them are displayed with
a black square (
■) in the lower right corner of the key.
If you select a key that already has settings stored in it, the
settings are displayed.
If there are more stored copy settings than are currently
displayed, you can scroll through the list by pressing [
▼] or [▲].
If you select a key without settings:
A screen appears, asking for your confirmation to store the
settings.
Press [Yes].
The message appears for approximately
two seconds on the touch panel display.
The key in which you stored the settings is displayed with a black
square (
■) in the lower right corner, and the stored settings are
displayed.
To cancel storing the settings, press [No].
If you select a key that already has settings stored in it:
A screen appears, asking for your confirmation to overwrite the
previous settings.
Press [Yes].
The message appears for approximately
two seconds on the touch panel display.
The key in which you stored the settings is displayed with a black
square (
■) in the lower right corner, and the stored settings are
displayed.
To cancel overwriting the settings, press [No].
8. Press [OK].
9.
Press [Done].
–
–
–
●
–
–
●
–
–
Naming a Memory Key
1. Press (COPY).
2.
Press [Special Features].
3. Press [Mode Memory].
4. Press [Store/Erase].
5. Press [Register Name].
6.
Select a key ([M1] to [M4]) to name, then press
[Next].
Keys that already have settings stored in them are displayed with
a black square (
■) in the lower right corner of the key.
If you select a key that already has settings stored in it, the
settings are displayed.
You can also name keys with no settings stored in them.
If there are more stored copy settings than are currently
displayed, you can scroll through the list by pressing [
▼] or [▲].
–
–
–
–