Canon imageCLASS MF7470 - Manual (Page 349)

1
2
3
4
5
6
7
8
9
10
11
10-19
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Load Paper.
Description The machine has run out of paper. No more
prints can be made.
Action Load paper. (See “Set Up the Machine,” in the
Starter Guide.)
Description The paper drawer is not inserted correctly.
Action Insert the paper drawer properly. (See “Set Up
the Machine,” in the Starter Guide.)
LTR Load paper.
Description The optimum paper size selected by the
Automatic Paper Selection mode is not available
in the machine.
Action Load the indicated paper size into the machine. If
you press (Start) while this message is
displayed, prints are made with the currently
selected paper size.
Action When the message continues to be displayed
even if the indicated paper size is loaded, set
Drawer Eligibility For APS/ADS in Common
Settings (from the Additional Functions screen)
for that paper drawer to [On]. (See “Automatic
Paper Selection/Automatic Drawer Switching,”
on p. 2-21.)
No response. (imageCLASS MF7480/MF7470 Only)
Description The server was not running when you tried to
send.
Action Check the destination.
Description The network connection was lost when you tried
to send. (Either you could not connect to the
destination or the connection was lost before the
job could complete.)
Action Check the status of the network.
Description A TCP/IP error occurred when you tried to send
an e-mail or I-fax.
Action Check that the network cables and connectors
are properly connected.
No response from the server. Check the settings. (imageCLASS
MF7480/MF7470 Only)
Description The specified server settings are incorrect, or the
server is not turned ON. Alternatively, the
machine’s TCP/IP resources may be low.
Action Wait for a while, and try browsing again. If you
still fail, try selecting another server.
Out of resources. Wait for a moment, then perform operation again.
(imageCLASS MF7480/MF7470 Only)
Description You cannot browse the network due to a lack of
TCP/IP resources. This may be because
documents have just been continuously sent or
are being continuously sent through FTP or
Windows (SMB).
Action Wait for a while, and try browsing again.