Canon PC170 - Manual

2
1
Congratulations on your purchase of a Canon Personal Copier!
IMPORTANT SET-UP INSTRUCTIONS
PLEASE READ ENTIRELY BEFORE USING COPIER!
1 Place the machine on a flat, level surface. Remove the copier from its
shipping bag and peel off all packing tape. Gently open the copy tray
and feed tray all the way.
NOTE: For the PC170, attach the copy tray to the left side of the copier.
2 Slide the platen to the left until the mark is exposed.
3 Press the top cover release button and lift open the top cover so that it
stands upright.
4 Remove the protective material completely.
5 Grip the end of the cartridge, and pull it out of the copier.
Although the cartridge comes already installed in the main unit, you cannot make copies
until after you have completed the following steps.
6 Hold the cartridge level so that the side with the written instructions is
facing up. Rock the cartridge several times to the right and left at a 90°
angle to evenly distribute the toner within the cartridge.
IN THE USA CALL:
1-800-828-4040
IN CANADA CALL:
1-800-263-1121
8 a.m. to 8 p.m. EST, Mon. - Fri., except holidays.
24 hours - 7 days / week
*The Canon Help Desk must receive your request for this service by 4 p.m. (EST) (3 p.m. EST in Canada) to ensure next
business day OVERNITE EXCHANGE SERVICE. (Two business days EXCHANGE SERVICE for Alaska and Hawaii.) Canon
does not guarantee next business day service in the event of the occurrence of factors beyond Canon’s reasonable control.
PC170 Models ONLY
USA and Canada ONLY
IF THIS COPIER IS NOT WORKING PROPERLY,
DO NOT RETURN IT TO YOUR RETAILER.
OVERNITE EXCHANGE SERVICE
OVERNITE EXCHANGE SERVICE is a program that expedites, by the next business day*, the exchange
of a non-working copier with a replacement copier during the One Year Parts and Labor
Limited Warranty. The replacement copier you receive will be a refurbished unit and will be
covered for the balance of the period remaining on your original warranty.
OVERNITE
EXCHANGE
7 Place the cartridge on a flat, level surface. Grip the sealing tape and pull
it straight out of the cartridge.
Do not pull the sealing tape out at an angle.If the sealing tape breaks before being pulled
out fully, you will not be able to use the cartridge. The sealing tape is approximately 20”
long. Be sure to pull the sealing tape completely out.
8 Hold the cartridge so that the arrow on the side with the written
instructions is pointing away from you.Then, insert the cartridge into the
copier as far as it will go.
9
Close the top cover by pressing down firmly on the part marked .
10 Return the platen to the center position.
FT5-0095 (000) xx2006xx ©CANON INC. 2006 PRINTED IN THAILAND
PC170_pera.pm6 06.4.6, 9:48 1